Replacing the power button board
Tools you need to complete this task:
Screws removed during this task:
www.packardbell.com
Phillips #0 screwdriver
Flat screwdriver
•
1 black M2×3 (hard drive)
•
1 black M2.5×6 (optical drive)
•
2 M2.5×6 black (palm rest - top side)
•
in
step 13
of the
•
Indicated by B in
page 49
•
2 black M2×4 (power button board)
To replace the power button board:
1
Complete the steps in
2
Complete the steps in
3
If the notebook has a wireless card installed, remove the card from the old
system board and install it on the new system board by following the
instructions in the
4
Remove the hard drive by performing steps
hard drive"
procedure on
5
Remove the optical drive by performing steps
optical drive"
procedure on
6
Remove the palm rest by following steps
rest"
procedure on
7
Turn the palm rest so that its underside is facing up.
or
Non-marring plastic scribe
6 M2×3 black (palm rest - base side) - Indicated by A
"Replacing the palm rest"
9 black M2.5×6 (palm rest - base side) -
step 13
of the
"Replacing the palm rest"
"Preparing the notebook" on page
"Removing the battery" on page
"Replacing the wireless card"
page
40.
page
45.
page
49.
procedure on
page 49
procedure on
37.
38.
section on
page
3
and
4
of the
"Replacing the
3
and
4
of the
"Replacing the
7–16
of the
"Replacing the palm
43.
59