Packard Bell EasyNote NM85 Service Manual page 76

70
CHAPTER 3: Replacing notebook components
10
Remove the optical drive by performing steps
optical drive" procedure on
11
Remove the keyboard by performing steps
keyboard" procedure on
Caution
The keyboard is connected to the notebook through a keyboard
cable. Disconnect this cable first before pulling the keyboard away
from the palm rest assembly.
12
Remove the palm rest by performing steps
rest" procedure on
from its system board connector.
13
Disconnect the USB board cable from its system board connector.
14
Remove the system board screw.
Note
A circuit board that is >10 cm
rectangle as shown in the previous image. Follow the local
regulations for disposing this type of circuit board.
The RTC battery has been highlighted with a yellow circle in the
previous image. Detach the RTC battery and follow the local
regulations for disposing it.
page 45.
page 47.
page 49, and then disconnect the Bluetooth module cable
2
has been highlighted with a yellow
3 and 4 of the "Replacing the
3–5 of the "Replacing the
7–16 of the "Replacing the palm