Replacing the LCD panel assembly
Tools you need to complete this task:
Screws removed during this task:
www.packardbell.com
Phillips #0 screwdriver
Flat screwdriver
•
1 black M2×3 (hard drive)
•
1 black M2.5×6 (optical drive)
•
2 M2.5×6 black (palm rest - top side)
•
in
step 13
of the
•
Indicated by B in
page 49
•
4 black M2.5×6 (LCD panel hinges)
To replace the LCD panel assembly:
1
Complete the steps in
2
If the notebook has a wireless card installed, complete the steps in
"Removing the bay cover" on page
If there's no wireless card installed, proceed to
3
Remove the hard drive by performing steps
hard drive"
procedure on
4
Remove the optical drive by performing steps
optical drive"
procedure on
5
Remove the keyboard by performing steps
keyboard"
procedure on
Caution
The keyboard is connected to the notebook through a keyboard
cable. Disconnect this cable first before pulling the keyboard away
from the palm rest assembly.
6
Remove the palm rest by following steps
rest"
procedure on
or
Non-marring plastic scribe
6 M2×3 black (palm rest - base side) - Indicated by A
"Replacing the palm rest"
9 black M2.5×6 (palm rest - base side) -
step 13
of the
"Replacing the palm rest"
"Preparing the notebook" on page
39, and then unplug the antenna cables.
page
40.
page
45.
page
47.
page
49.
procedure on
page 49
procedure on
37.
step
7.
3
and
4
of the
"Replacing the
3
and
4
of the
"Replacing the
3–5
of the
"Replacing the
7–16
of the
"Replacing the palm
61