Table of Contents
Advertisement
56
CHAPTER 3: Replacing notebook components
7
Insert a small flat-blade screwdriver or non-marring scribe between the
touchpad board and the palm rest's underside, and carefully pry the board
loose.
8
Remove the touchpad board from the palm rest.
Note
A circuit board that is >10 cm
rectangle as shown in the above image. Follow the local regulations
for disposing this type of circuit board.
9
Observing the same orientation as the old touchpad board, secure the new
board on the palm rest.
10
Cover the new touchpad board with the double-sided tape.
11
Insert the touchpad cable to the touchpad board cable connector, and then
close the clip to lock the cable in place.
12
Reinstall the palm rest by performing steps
rest"
procedure on
13
Reinstall the keyboard by performing steps
keyboard"
procedure on
14
Reinstall the optical drive by performing steps
the optical drive"
15
Reinstall the hard drive by performing steps
hard drive"
procedure on
16
If you have disconnected any wireless antennas, reconnect them now.
17
Reinstall the bay cover.
18
Reinstall the battery.
2
has been highlighted with a yellow
page
49.
page
47.
procedure on
page
45.
page
40.
17–19
of the
"Replacing the palm
7–11
of the
"Replacing the
10
and
11
of the
8
and
9
of the
"Replacing the
"Replacing
- Quick Links:
- Memory
- Hard Disk Drive
Hide quick links:
Advertisement
Table of Contents
