Download  Print this page

Procedurec - Kenmore 580.75085 Owner's Manual

Through-the-wallair conditioner.
Hide thumbs

Advertisement

Table of Contents
PROCEDURE
C
_1
Redirect the louvers at the back of the wall
sleeve to 60 ° angle as shown in the FIG 16.
The use of pliers is recommended.
7 3132"
Rear
Louvers
(Top View)
FIG. 16
I_ll
If the wall sleeve already has a rear grille, skip
to step 4. If the wall sleeve does not have a rear
grille or Iouvered panel, install the plastic grille
from the kit. Cut the plastic grille to 26-1/2" wide
and 15-1/2" high. Place the plastic grille to the
inside of the wall sleeve at the rear flange.
Place the plastic grille
FIG.
17
I_
Fasten the 4 washer screws to secure the grille
to the wall sleeve. If you need plastic nuts to
mount plastic grille to the inside of the wall
sleeve, there are plastic nuts in the installation
kit. The nuts are installed from the inside of the
sleeve and are pressed into the square holes of
the rear flanges.
Fasten the screws
FIG 18
I_
Remove the backing from the Horizontal
Insulation strip 237/32x 13/8x 13n6 and attach
that to the inside right of the sleeve as shown
below. Remove the backing from the Around
Insulation strip
5927/32 X
13/8X 13/8and attach
that to the inside front of the sleeve as shown
below<
Indoor
Outdoor
_lf
the depth of your existing sleeve is less than
or equal to 18", skip to step 7. Otherwise, cut
the baffles and the support blocks according to
Length "A" in the table below.
Depth"D" of the existing Length"A"
wailsleeve (inches)
(inches)
t8 <D_<t8-%
3/4
18-% <D_t9-3/_
1-3/4
t9-3/_ <D_<22
4
_F
Baffle
IG. 20
r_
Remove the backing from the support blocks
and attach them to the inside of the wall sleeve
as shown FIG 21. Slide the baffle into slots of
the support blocks
Wall
Wall
Sleeve
J
Support
Block
FIG. 21
-10-

Advertisement

Chapters

Table of Contents

   Related Manuals for Kenmore 580.75085

This manual is also suitable for:

580.75116580.75135

Comments to this Manuals

Symbols: 0
Latest comments: