Important Information - Infinity 600 CF Owner's Manual

600 CF Users Instructions
SECTION ONE
The 600 CF is battery operated; therefore no mains electrical supply is required. Power to the
appliance is provided by 6 high power alkaline 1.5V batteries ("C" size) (a spare set of 6 "C" batteries
is supplied with the appliance
An audible repeated bleep warning indicates that the appliance batteries need changing or charging
(if rechargeable batteries have been used).
Important: Batteries should be changed as soon as possible as the appliance will not light if
the battery power gets to low.

IMPORTANT INFORMATION


The appliance is for use on Natural Gas (G20 @ 20mbar) and LPG (G21 @ 37mbar) only.

The chimney or flue (unless new or previously used with a gas appliance) shall be swept before
installation if it has been used for solid fuel.

Failure to install appliance correctly could lead to prosecution.
In GB (Great Britain), the appliance must be installed by a competent person i.e. Gas Safe-
registered, in accordance with the GAS SAFETY (INSTALLATION AND USE) REGULATIONS,
The Building Regulations (or The Building Regulations (Scotland) or The Building Regulations
(Northern Ireland)) and The Current I.E.E. Wiring Regulations, if appropriate.
In IE (Ireland), the appliance must be installed by a competent person and installed in accordance
with the current edition of I.S.813 Domestic Gas Installation, the current Building Regulations and
the current ETCI rules for electrical installation, if appropriate.

The glass front of this fire acts as a dress guard, conforming to BS 1945 (1997) however; a
fireguard conforming to BS6539 (1997) must be used to protect young children, the elderly or
infirm.

The appliance MUST NOT be used with the glass safety screen removed or if it is damaged or
cracked.

During initial firing, an odour may be evident. This is the starch binder used during the
manufacture of the fibre components of the fire, and there are no harmful effects produced.

During the normal operation of the fire some black staining may appear on some parts of the fuel
bed. This is quite normal and adds to the appearance of the appliance. However, if excessive
black staining does occur it may be due to the fuel bed being incorrectly laid. This should be
checked prior to contacting a service engineer.
Introduction Continued
4 LT5889 issue 7(10/12)