Section Eight - Infinity 600 CF Owner's Manual

600 CF
Installation Instructions

SECTION EIGHT

CLASS ONE INSTALLATION WITH FLEXIBLE LINER USING (GATHER HOOD
OPTIONAL EXTRA Part No A-0293)

Fix the gather hood assembly to the rear top of the firebox using the four fixing screws
provided within the kit.

The front wall structure of the chimney will need cutting away to provide height to give access
to the top of the gather hood. This will allow connection of a 5"flexable flue liner which is
suitable for gas.
GAS SUPPLY ROUTING
Use rigid or semi – rigid tube to connect the supply. Determine the gas supply pipe route to the
appliance before installing the fire.
REMOVING GLASS PANEL

Remove the trim, which is held in position with magnets.

Remove the two 6mm wing nuts located on the left hand and right hand bottom corners of firebox.

Pull the glass frame assembly forward to clear the fixing studs. Once clear pull downwards to
clear the glass retaining bracket.

Once the fuel bed has been laid reassemble in reverse order.

Ensure that the trim is the correct orientation.
CONNECTING THE GAS SUPPLY
Note: - An isolation valve may be fitted in the gas supply adjacent to inlet pipe.
For a concealed connection: -

Remove the burner assembly by removing six screws holding the burner tray to carrier.

Remove the rubber (blind) grommet from the supply pipe inlet hole at the rear of the outer box
and slide the box over the supply pipe and fix to the surround using one of the methods described
in the next section.

Refit the grommet over the pipe and seal around the inlet hole.

Refit the burner unit and make connection between the supply isolating valve and the burner
assembly inlet.
Positioning Remote receiver Battery position
 Connect battery pack to appliance and insert batteries.(see section 2)
 Position the battery pack within the insulation sleeve.
 Place the remote receiver on the fire box base.
 Reposition the Glass assembly and trim.
 Fit the three "AAA" batteries (supplied) to remote hand set (see Section 2).
 Press the ON / OFF key for at least 2 seconds, on release a bleep sound be heard and the
ignition process will start. If the fire continues to bleep this may indicate a loose connection or
badly loaded batteries.
To Install the Appliance Continue
15 LT5889 issue 7(10/12)