Table of Contents
Advertisement
480 HD USERS INSTRUCTIONS
Important Information
The appliance is for use on Natural Gas (G20 @ 20mbar) only.
The Chimney or flue (unless new or previously used with a gas appliance) should be swept
before installation if it been used for solid fuel.
In Great Britain, the appliance must be installed by a competent person whose name
appears on the gas safe register. All Gas Safe engineers should possess an ID carrying the
logo below.
In IE (Ireland), the appliance must be installed by a competent person and installed in
accordance with the current edition I.S 813 Domestic Installation.
The glass front of this appliance acts as a dress guard, conforming to BS 1945 (1997) however
a fireguard to BS6539 (1997) must be used to protect young children, the elderly or infirm.
The Appliance must not be used with the glass safety screen removed or if it is damaged or
cracked.
During initial "burn off", an odour may be evident during the first few hours of use. This is due
to the surface coating on the metal work "burning off". The odour produced is harmless and
will disappear after a short period of time.
During the normal operation of the fire some black staining may appear on some parts of the
fuel bed. This is quite normal. However, if excessive black staining occurs it may be due to the
fuel bed shapes laid incorrectly. This should be checked prior to contacting a service
engineer.
Care must be taken to prevent any damage being caused to surrounding soft furnishing or
decoration. Many embossed vinyl coverings may become discoloured if placed too close to
the appliance. It is suggested that a sample of the proposed wall covering should be place
above the appliance at its hottest point first. The appliance should then be run on high rate
over a couple of days
It is advised that this appliance should be serviced annually as recommended by Gas Safe.
This is more likely to provide trouble-free operation and is a requirement of the extended
warranty.
In GB (Great Britain) the fire does not normally require purpose built ventilation, but if for any
special reason purpose built ventilation is provided it should be checked periodically to
ensure freedom from obstructions.
In IE (Ireland) permanent ventilation must comply with the current edition of IS813.
LT 7602 Issue No2 (07/17)
P a g e
| 4
Advertisement
Table of Contents
