Life Gear G1 Owner's Manual page 37

Tool:
2 Wrenches (19-17)
(33) Leg Extension Cable
Routing the Leg Extension Cable
Insert the Leg Extension Cable (33) around the Pulley (60) on the Side Pulley Bracket (4)
then pull it upwards to the Pulley (60) on the Pulley Plates (27). Draw the Leg Extension
Cable (33) around the Pulley (60) on the Pulley Plates (27) then pull it downwards to the
Pulley (60) on the Main Base Tube (1). Draw the Leg Extension Cable (33) around the
Pulley (60) on the Main Base Tube (1) then pull it upwards to the Pulley (60) on the Crossed
Double Floating Pulley Bracket (18). Draw the Leg Extension Cable (33) around the
Pulley (60) on the Crossed Double Floating Pulley Bracket (18) then pull it downwards to the
Pulley (60) on the Main Base Tube (1). Draw the Leg Extension Cable (33) around the
Pulley (60) on the Main Base Tube (1) then pull it forwards to the Pulley (60) on the Main
Base Tube (1). Pull the Leg Extension Cable (33) forwards to the Leg Extension Tube (8).
Attach one end of the Leg Extension Cable (33) onto the Leg Extension Tube (8) with one
M10x25 Hex Bolt (83), one M10 Nylon Lock Nut (68), and two Ø10 Flat Washers (73).
Tighten bolt and nut with two Wrenches provided.
Connect the Hook (63) to the ball stopper end of the Leg Extension Cable (33) and Coil
Chain (64). Connect the other Hook (63) to the Coil Chain (64) and Low Row Bar (16) or
Ankle Strap (35).
PLEASE REFER TO THE "CABLE LOOP DIAGRAM" SECTION ON PAGE
24.
Hardware:
1 Hex Bolt (M10x25) 1 Nylon Lock Nut (M10)
2 Flat Washers (Ø10)
2Hooks 1 Coil Chain (200) 1 Ankle Strap
36