Life Gear G1 Owner's Manual page 32

Tool:
2 Wrenches (19-17)
Step 3
Attach two Pulleys (60) onto the Crossed Double Floating Pulley Bracket (18) with two
M10x45 Hex Bolts (84), two M10 Nylon Lock Nuts (68), and four Ø10 Flat Washers (73).
Tighten bolts and nuts with two Wrenches provided.
Hardware:
2 Pulleys
2 Hex Bolts (M10x45) 4 Flat Washers (Ø10) 2 Nylon Lock Nuts (M10)
Routing the Butterfly Arm Cable
Insert the other end of the cable around the Pulley (60) on the left Pulley Bracket (20) then
pull it downwards to the Crossed Double Floating Pulley Bracket (18). Draw the Butterfly
Arm Cable (31) around the Pulley (60) on the Crossed Double Floating Pulley Bracket (18)
then pull it upwards to the right Pulley Bracket (20). Draw the Butterfly Arm Cable (31)
around the Pulley (60) on the right Pulley Bracket (20) then pull it forwards to the Right
Butterfly Arm (12).
Attach the other end of the Butterfly Arm Cable (31) onto the Right Butterfly Arm (12) with
one M10x25 Hex Bolt (83), one M10 Nylon Lock Nut (68), and two Ø10 Flat Washers (73).
Tighten bolt and nut with two Wrenches provided.
PLEASE REFER TO THE "CABLE LOOP DIAGRAM" SECTION ON PAGE
24.
Hardware:
1 Hex Bolt (M10x25) 1 Nylon Lock Nut (M10)
2 Flat Washers (Ø10)
31