Life Gear G1 Owner's Manual page 20

29
71
79
9
Step 9
Attach the Backrest (28) onto the Main Support Tube (2) with two Ø8 Curve Washers (76)
and two M8x80 Hex Bolts (82). Tighten bolts with the Wrench provided.
Attach the Seat Pad (29) onto the Seat Frame (9) with four Ø6 Flat Washers (71) and four
M6x20 Hex Bolts (79). Tighten bolts with the Wrench provided.
Insert the Seat Frame (9) with Seat Pad (29) into the seat support frame plastic bushing of
the Seat Support Frame (7). Adjust the seat position and insert the Round Knob (57).
Turn the Round Knob (57) in the clockwise direction to tighten.
Adjusting the Seat Height
Turn the round knob in a counterclockwise direction until it can be pulled out. Pull out the
round knob and then slide the seat frame up or down direction to the suitable position.
Lock the seat frame in place by releasing the round knob and sliding the seat frame up or
down slightly until the round knob "pops" down into the locked position. For added safety,
tighten the round knob in a clockwise direction.
Hardware:
2 Hex Bolts (M8x80) 2 Curve Washers (Ø8) 4 Hex Bolts (M6x20) 4 Flat Washers (Ø6)
1 Round Knob
28
9
7
57
2
82
76
82
76
19
Tool:
1 Wrench (14-10)