Life Gear G1 Owner's Manual page 28

Tool:
2 Wrenches (19-17)
Step 3
Attach two Pulleys (60) onto the Double Floating Pulley Bracket (19) with two M10x45 Hex
Bolts (84), two M10 Nylon Lock Nut (68), and four Ø10 Flat Washers (73).
Tighten bolts and nuts with two Wrenches provided.
Hardware:
2 Pulleys
2 Hex Bolts (M10x45) 4 Flat Washers (Ø10) 2 Nylon Lock Nuts (M10)
Routing the Lat Bar Cable
Insert the cable around the Pulley (60) at the front of the Pulley (60) on the Top Frame (3)
then pull it towards to the second Pulley (60) and third Pulley (60) on the Top Frame (3).
Draw the Lat Bar Cable (30) around the Pulley (60) then pull it downwards to the Double
Floating Pulley Bracket (19). Draw the Lat Bar Cable (30) around the Pulley (60) on the
Double Floating Pulley Bracket (19) then pull it upwards to the forth Pulley (60) on the Top
Frame (3). Draw the Lat Bar Cable (30) around the Pulley (60) then pull it downwards to
the Guide Rod (41). Thread the bolt at the end of the Lat Bar Cable (30) into the opening
on top of the Guide Rod (41) to secure the cable.
PLEASE REFER TO THE "CABLE LOOP DIAGRAM" SECTION ON PAGE
24.
(30) Lat Bar Cable
27