Plotter Default Conditions - HP 7470A Interfacing And Programming Manual

Plotter Default Conditions
Plotting mode
Relative character direction
Line type
Line pattern length
Input window
Relative character size
Scale
Symbol mode
Tick length
(on either side of axis)
Standard character set
Alternate character set
Label terminator
Character slant
Mask value
Digitize clear
Pen velocity
*Chord angle
Absolute (P A)
Horizontal (DR 1 ,0)
Solid line
4%of the distance from P1 to P2
Mechanical limits of plotter
(SR .75 , 1.5)
width = 0.75% of (P2XV Pix)
height : 1.5%of (P2y - Ply)
Off
Off
0.5% of (P2x —Plx) or (P2y - Ply)
Set 0
Set 0
ETX (ASCII decimal equivalent 3)
00
223 , O,0
On
38.1 cm/s (15 in./s)
Set to 5 degrees for AA, AR, and CI
P1 and P2 are changed only with the initialize command (IN). They are
not affected by device clear and the default command (DF).
*Applicable only to RS-232-Cplotters that have the serial prefix number 2312A
or higher.
REFERENCE MATERIAL C-5