HP 7470A Interfacing And Programming Manual page 201

LB
LT
0A
The Label Instruction Page5-7
LB c . . . c t
Purpose: Draws the character string using the currently selected
character set.
Parameters: c...c — ASCII characters which may include control
characters.
Terminator: t —— label terminator defined by DT. Default is ETX,
decimal 3.
The Line Type Instruction Page4-6
LT pattern number (, pattern length) (;)
Purpose: Sets the line type used in drawing lines.
Parameters: pattern number — integer between 0 and +6. Omitting
parameter causes solid line.
0— specifies dots only at the points that are plotted.
One pattern length
No parameter (Default Value)
pattern length — decimal, 0 to 127.9999,a percentage of
diagonal distance between P1 and P2. Default 4%.
The Output Actual Position and
Pen Status Instruction
Page 7-3
0A (;)
Purpose: Used to output the pen's physical position at time of
command.
Response: X,Y,P [TERM] —integers, in ASCII.
X,Y —in plotter units within current window.
P — 0, pen up or 1, pen down.
INSTRUCTION SYNTAX B-5