The Line Type Instruction, Lt - HP 7470A Interfacing And Programming Manual

Plot showing symbol mode:
33
The Line Type Instruction, LT
DESCRIPHDN The line type instruction, LT, specifies the type of line
that will be used with PA and PR commands.
m This instruction can be used with PA and PR commandsto
draw dashed or dotted lines. This facilitates trace differentiation on
multipleline graphs and enables emphasis or deemphasis of plotted
lines or grids. One line type causes only dots to be plotted at each data
point.
3YNTAX L T pattern number (,pattern length) (terminator)
or
L T (terminator)
EXPLANATIONShown below are the line patterns and their pattern
numbers.
0- specifies dots only at the points that are plotted.
One pattern length
No parameter (Default Value)
The shaded portion of each of the line patterns above is one complete
segment of the pattern.
4-6 ENHANCING THE PLOT