HP 7470A Interfacing And Programming Manual page 199

CS
DC
DF
DI
DP
DR
The Designate Standard Character Set Page5-3
Instruction
C8 In (;)
Purpose: Designates the standard character set.
Parameter: integer, 0 through 4; default set 0.
The Digitize Clear Instruction Page6-3
DC ( ;)
Purpose: Clears digitize mode without entering a point from the
front panel.
The Default Instruction Page1-10
DF ;
Purpose: Returns plotter to default conditions. See the table in
Appendix C.
The Absolute Direction Instruction Page5-10
DI run, rise ;
Purpose: Sets the direction of labels.
Parameters: run, rise —decimal values, unitless. At least one must be
nonzero, i.e., |parameter| 2 0.0004 .
Omitting parameters causes horizontal labels and is the
same as Dl1,0.
The Digitize Point Instruction Page6-2
DP (;)
Purpose: Places plotter in digitize mode waiting for point to be
entered from front panel.
The Relative Direction Instruction Page5-11
DR run, rise ;
Sets the direction of labels.
decimals, -128 to +127.9999.
run is % of (P2,; / Plx), rise is % of (P2y —Ply).
Purpose:
Parameters:
Omitting parameters causes horizontal labels as does
DR1,0.
INSTRUCTION SYNTAX B-3