The Reset Handshake Instruction, Esc . R - HP 7470A Interfacing And Programming Manual

The Reset Handshake Instruction,
ESC . R
DESCRIPTIONThe reset handshake instruction, ESC. R, resets all
handshake parameters to their default values.
E The instruction may be used to set the p1otter'shandshake
responses to a known state with hardwire handshake enabled.
svumx , R
EXPLANAHUNExecuting this command is the same as executing the
following commands without parameters: ESC . @, ESC . H, ESC . I,
enquiry character
acknowledgment string
turnaround delay
output trigger character
echo terminate character
output terminator
output initiator
intercharacter delay
immediate response string
monitor mode
hardwire handshake (pin 20)
ESC . M, and ESC . N. K
The following table shows the default values of parameters used to
establish handshakes.
Parameter Value
block size 80
0 —no enquiry character
0 —no acknowledgment string
0 — no delay
0 —no trigger character
0 —no echo terminate character
13;0; — carriage return
0 —no output initiator
O — no delay
0 —no immediate response string
disabled
enabled
10-40 RS-232-C/CCITT V24 INTERFACING