3D Systems ProJet x60 Series User Manual page 34

®
ProJet x60 Series User Guide Routine Cleaning
4. Position the squirt bottle close to the station and squirt water into the service station.
5. Use the cotton swabs or a paper towel and wipe the service station thoroughly.
6. Use a brush or the Pick to scrape excess Core out of any corners.
7. Thoroughly wipe the Service Station clean.
8. Wipe up any water that may have spilled onto the Deck or Build Bed. Vacuum up any loose Core. Do
not vacuum the service station itself.
Important: Never vacuum up water or other fluids - it will clog the vacuum system.
9. Remove the paper towels from the front overflow. Close the printer top cover.
3dscentral.3dsystems.com 28 All Rights Reserved
5/12/13