®
ProJet
x60 Series User Guide
6. Wipe the Piston Screw clean of old grease, dust, etc.
7. Squirt grease onto a paper towel and spread the grease up and down the Piston Screw to evenly dis-
tribute it over the entire length of the screw.
8. Move the Build Bed up and down through its full range of travel a couple of times to finish lubricating
the screw. Use the LCD menu items
CHAMBER > LOWER PLATFORM
platform.
9. Wipe off any grease that may collect at the bottom of the screw with a clean paper towel.
10. Replace the side and back cover panels.
11. Reset the Maintenance Counter in 3D Print.
3dscentral.3dsystems.com
5/12/13
Number
Component
1
Piston Screw
BUILD CHAMBER > RAISE PLATFORM
. Don't forget to hold down the Control Knob to raise or lower the
43
Printer Maintenance
and
BUILD
All Rights Reserved