Empty The Debris Separator - 3D Systems ProJet x60 Series User Manual

®
ProJet x60 Series User Guide Routine Cleaning
Important: Never vacuum up water or other fluids - it will clog the vacuum system.

3.2 Empty The Debris Separator

After vacuuming, empty the Debris Separator. The Debris Separator catches any large particles and keeps
those pieces from being recycled into the feeder. To empty the Debris Separator follow the steps below.
1. Pull the Debris Separator out of its holder on the printer.
2. Empty the contents into a trash receptacle.
3. Use the soft brush found in the Accessory Kit to brush any caked-on Core from the screen.
4. Return the empty Debris Separator to its holder. Be sure to push the Separator flat against the panel
for a secure fit.
3dscentral.3dsystems.com 24 All Rights Reserved
5/12/13