Clean The Spreader Roller - 3D Systems ProJet x60 Series User Manual

®
ProJet x60 Series User Guide

6.5 Clean The Spreader Roller

Frequency: On a regular schedule, depending on your usage. Or, whenever the printer has problems
related to the surface finish of horizontal surfaces.
1. On the LCD, select
BUILD CHAMBER
2. Move the Fast Axis out over the build bed.
3. On the LCD, select BUILD CHAMBER
4. On the LCD, select ROLLER ON/OFF
5. Using a paper towel dampened with distilled water, clean the Spreader Roller thoroughly by reaching
up from underneath.
6. Dry the roller thoroughly with a clean dry paper towel.
7. On the LCD, select
ROLLER ON/OFF
8. When finished, select
9. Make sure the roller is completely dry before attempting to spread any Core.
3dscentral.3dsystems.com
5/12/13
then
LOWER PLATFORM
then CONTROL ROLLER
to turn the Spreader Roller on.
Number Component
1 Spreader Roller
to turn the Spreader Roller off.
EXIT (ROLLER OFF)
. Lower the build bed by 4-5 inches.
.
to return to the Main Menu.
45
Printer Maintenance
All Rights Reserved