®
ProJet
x60 Series User Guide
5.4 Add Binder
If there is not enough binder in one or more of the cartridges, 3DPrint displays
Status dialog.
Important: Do not add binder unless you are prompted to in the 3DPrint Printer Status dialog.
To add binder, follow the steps below.
1. Pull the empty binder cartridge out of its housing on the printer.
2. Get a new binder cartridge. Check the expiration date, and check the cartridge label for the correct ori-
entation.
3. Insert the cartridge into its housing. Ensure the cartridge is pushed all the way in. You should feel it
gently snap into place.
Important: If a cartridge does not snap into place, do not force it. Check the orientation and that it is
the correct type and try again.
3dscentral.3dsystems.com
5/12/13
37
Additional Operations
BINDER LOW
in the Printer
All Rights Reserved