Setting The Cleaning Agent Dosage Concentration Level; 1.3 Venting The Dispensing System; 1.4 To Save Your Changes - Miele G 8066 Operating Instructions Manual

Programming special functions
1.2 Setting the cleaning agent
dosage concentration level
If the dispensing method has been
programmed for liquid cleaning agent,
you can alter the dispensing
concentration as follows.
Set the concentration level
according to the manufacturer's
recommendations.
Example: If the manufacturer
recommends a concentration level of
0.5%, a value of 0.50 should be set.
^ Call up Programming level 2
(see 1.1).
Then, or if you were already in
Programming level 2, set the dosage
concentration level as follows:
^ Press the z button repeatedly until
2.02 appears in the display.
^ Press the A button.
The liquid cleaning agent dosage
concentration level will appear,
displayed as a %:
0.00 - 1.00 = 0.0 % - 1 % dosage
concentration level (0.20 = 0.2 %, the
factory default setting).
^ Press A repeatedly or hold pressed
in until the required value appears in
the display.
The dosage concentration level has
now been set.
Value set:
34
Only for DOS Module C 60:
Also set the dosage selector on the
DOS Module to position "10".
Proceed to step 1.4 if you do not want
to make any other changes to settings
in this programming level.

1.3 Venting the dispensing system

^ Call up Programming level 2
(see 1.1).
Then, or if you were already in
Programming level 2, vent the
dispensing system as follows:
^ Press the z button repeatedly until
2.03 appears in the display.
^ Press A. "do1" will appear in the
display.
^ Press A again.
The dispensing system will be vented
automatically. 0 will appear in the
display when the venting process has
finished.
Proceed to step 1.4 if you do not want
to make any other changes to settings
in this programming level.

1.4 To save your changes

^ Press 6. SP will appear in the
display.
^ Press 6 again. The alteration is now
saved.
^ Switch off the machine with the Z
button.