Miele G 8072 Operating Instructions Manual
Commercial dishwasher
Hide thumbs
Also See for G 8072:
- Operating instructions manual (52 pages) ,
- Fitting instructions manual (176 pages)
Table of Contents
Related Manuals for Miele G 8072
Summary of Contents for Miele G 8072
-
Page 1: Operating Instructions
Operating instructions Commercial dishwasher G 8072 To avoid the risk of accidents or damage to the machine it is essential to read these operating instructions before it is installed, commissioned and used for the first time. M.-Nr. 05 905 900... -
Page 2: Table Of Contents
Contents Description of the machine ......... . 4 Areas of application . - Page 3 Contents Using special programmes ......... 32 Short programme for lightly soiled loads .
-
Page 4: Description Of The Machine
Areas of application The dishwasher is fitted with an auto- matic start mechanism on the hood. This Miele dishwasher is a commercial Shutting the hood starts the machine on machine with a tank system and hood the last selected programme. -
Page 5: Information For The User
Description of the machine Information for the user It is important that you are fully conversant with the functioning and operation of your machine and any optional features. Take particular note – the effect of the water temperature on washing results (see sections "How the dishwasher works"... -
Page 6: Finding Your Way Around The Machine
Finding your way around the machine Controls a On/Off control h Miele Service Technician’s fault diagnosis control (for use by a Miele b Fault light Service Technician only) c Universal programme control i Control to activate lower temperature d Boiler water temperature display *) -
Page 8: Description Of The Machine
Finding your way around the machine Description of the machine a Hood h Basket carrier with adjustable rails b Top spray arm for rinse i Water tank with heating element (on right side wall). c Top spray arm for main wash Be careful Danger of burning! d Control panel See "Warning and Safety... - Page 9 Finding your way around the machine To the rear: l Water outlet m Connection points for optional rinsing agent (red) and liquid cleaning agent (blue) dispensers Right hand side panel: n Water inlet hose connection point...
-
Page 10: Warning And Safety Instructions
This machine should be requirements. Incorrect use can, commissioned and then maintained however, lead to personal injury and only by a Miele authorised and trained damage to property. Service Technician or other suitably Read the operating instructions qualified and competent approved carefully before starting to use this person. - Page 11 Only use Miele approved cleaning danger for others operators. Sharp agents in this machine. Use of knives etc. should be placed in baskets...
- Page 12 In critical applications where very agents which have been approved stringent requirements have to be by Miele. Foam can have an adverse met, it is strongly recommended that all effect on the cleaning process. the relevant factors for the process,...
- Page 13 Warning and Safety instructions Using accessories Only use genuine Miele accessories with this machine. Consult Miele on the type and application of such equipment. Disposing of your old machine Before disposing of your old machine first make it unusable. Disconnect from the mains, cut off the cable near the machine and any plug from the cable.
-
Page 14: Caring For The Environment
Caring for the environment Disposal of the packing Disposal of your old machine material Old machines contain materials which can be reclaimed or recycled. Please The transport and protective packing contact your dealer, your waste has been selected from materials which collection centre or scrap merchant are environmentally friendly for disposal about potential recycling schemes. -
Page 15: Before Using For The First Time
Before using for the first time Before using for the first time please pay special attention to the following points. Detailed information on these points can be found in the relevant sections of these Operating Instructions. Water softener For machines without an integral water softener, a separate water softener is recommended in areas with a water hardness ü... -
Page 16: Water Softener
Water softener Everything you need to know about the water softener The water needs to be softened to avoid calcium deposits building up on utensils and in the machine itself. To ensure a steady supply of soft water the water softener unit must always be: 1. - Page 17 Water softener Settings °d mmol/l °f Setting (German scale) 25*) *) factory setting...
-
Page 18: Programming The Water Softener
If the water hardness level changes, enter the new level following the above instructions. If the mains water hardness level is over 25 °d (4.5 mmol/l), please contact the Miele Professional Department about an on-site water softening system. -
Page 19: Adding Reactivation Salt
These could contain components which are insoluble in water which could result in damage to the water softener. If in doubt consult the Miele Professional Department. ^ Place the funnel provided in place. ^ Fill carefully with 1.5 kg of reactivation salt. -
Page 20: Salt Indicator Light
Water softener Salt indicator light When the k indicator lights up in the display, the reactivation salt will need to be replenished. See "Adding reactivation salt". The water woftener runs automatically during a programme. -
Page 21: Crockery And Baskets
Crockery and baskets Preparing the load for Select baskets and inserts which are appropriate for the application. washing, and loading the machine Items which are unsuitable for the dishwasher Preparing the load ^ Empty all containers and scrape – Cutlery with wooden or horn handles. residual food from crockery before –... -
Page 22: Loading Examples
Crockery and baskets Loading examples The dishwasher can be supplied with a standard range of baskets, or with baskets to suit your individual requirements. The diversity of inserts and baskets is so great that it is not possible to illustrate them all or give detailed instructions on their use here. -
Page 23: Fitting The Basket Carrier
Crockery and baskets Fitting the basket carrier The basket carrier is adjustable. The rails for the baskets can be fitted to the optional console, universal or feed-in table, so that the baskets can travel through the machine in a straight line or through it at a right angle. -
Page 24: Adding Cleaning Agent And Rinsing Agent
Adding cleaning agent and rinsing agent Topping up the cleaning agent: Only use cleaning agents formulated Powder cleaning agent will need to be for use in this type of machine. Do replenished manually after about 5 not use detergents formulated for washes. -
Page 25: Venting And Programming The Dispensing System
Venting and programming the dispensing system Venting the liquid dispensing Programming the dosage for system liquid cleaning agent If your machine is fitted with a liquid If your machine is fitted with a liquid dispensing system: dispensing system, and you want to programme it yourself: ^ Fill the container with liquid cleaning agent. -
Page 26: Measuring The Cleaning Agent
Venting and programming the dispensing system Measuring the cleaning agent Changing the brand of liquid cleaning agent If your machine is fitted with a liquid dispensing system, and you want to If you change the brand of your liquid programme it yourself: cleaning agent, you should rinse the system out with fresh water, even if the ^ The dishwasher must be switched... -
Page 27: Venting The Rinsing Agent Dispensing System
Venting and programming the dispensing system ^ Refit the siphon into the new cleaning Venting the rinsing agent agent container. dispensing system ^ Press [. Before using the machine for the first The heating up phase will begin. time, or if the container has not been The programme control X will light replenished on time or has been up red. -
Page 28: Programming The Rinsing Agent Dispensing System
You will require external dispensing succession. pumps to be fitted; please contact ^ Press control §. The rinsing agent Miele Professional for advice. concentration will be reduced to a minimum of 0.1 ml/l, or 10 in display ^ Press control °. The rinsing agent concentration will be increased to a maximum of 0.5 ml/l, or 50 in display... -
Page 29: Programme Chart
Short programme with reduced 60 s (other final rinse temperatures can only be altered final rinse temperature at 65 °C by a Miele Service Technician) Intensive programme with reduced 180 s final rinse temperature at 65 °C Emptying the tank/self-cleaning Approx for cleaning inside the cabinet. -
Page 30: Preparation
Preparation ^ Open the stopcock to the water supply. ^ Switch on the electricity at the mains. ^ Check that automatic cleaning agent and rinsing agent dispensers are full, if applicable (see indicator lights on control panel). Be careful not to splash cleaning agent or rinsing agent on your skin, as they can cause irritation. -
Page 31: Using The Universal Programme
Using the Universal programme ^ If powder cleaning agent is being dispensed manually: add approx. 120 g powder cleaning agent into the basket filter (see section "Adding powder detergent manually"). ^ Put one loaded basket only into the dishwasher. ^ Close the hood. ^ To select the Universal programme, press X. -
Page 32: Using Special Programmes
Using special programmes Short programme for lightly Programmes with reduced final soiled loads rinse temperature ^ Place the basket into the machine. Caution: danger of scalding with ^ Close the hood. hot water. After selecting a reduced final rinse temperature, the next ^ Press control 4. -
Page 33: Short Programme With Reduced Final Rinse Temperature
Using special programmes Short programme with reduced final rinse temperature ^ Place the basket into the machine. ^ Close the hood. ^ Press control 4. ^ Press control §. ^ Press control {. ^ Press control X. The programme starts. The machine starts automatically when the hood is shut. -
Page 34: Changing Programme
Changing programme The Universal and Special programmes can be changed whilst the hood is either open or closed. Changing a Special programme ^ Select the programme you want, e.g. the Short programme {. The previous programme is then cancelled. ^ Close the hood. ^ Press control X. -
Page 35: Changing The Setting For The Automatic Start Mechanism On The Hood
Changing programme Changing the setting for the automatic start mechanism on the hood The dishwasher is fitted with an auto- matic start mechanism on the hood. To deactivate or reactivate the automat- ic start mechanism, please contact the Miele Service Department. -
Page 36: Self-Cleaning Programme
Self-cleaning programme This programme cleans the inside of the dishwasher, and pumps the dirty water out of the tank. The dishwasher will switch off automatically once the Self-cleaning programme has finished. ^ Do not load the dishwasher. ^ Close the hood. ^ Press control Ä... -
Page 37: Switching The Dishwasher Off
Switching the dishwasher off When the Self-cleaning programme has finished, the dishwasher switches itself off. However, please be aware that the machine is still connected both to the electricity mains and to the water supply. ^ Close the stopcock to the water supply. -
Page 38: Cleaning And Care
Cleaning and care Cleaning the filters and cabinet The filter combination in the base of the tank should be inspected regularly and cleaned if necessary. Caution. Watch out for glass splinters which could cause injury. Cleaning the pump filter On the right hand wall of the water tank, there is a filter to protect the circulation pump. -
Page 39: Correcting Minor Faults
With the aid of the following explanatory Important: Switch the dishwasher notes, minor faults can be corrected off if the y symbol lights up by without contacting the Miele Service pressing control [. Then the Department. Read the following descriptions and charts. To avoid message "Err", with the fault code,... -
Page 40: Faults Without "Err" In The Display
Correcting minor faults Faults without "Err" in the display Display Problem Cause/Effect Remedy ^ Switch the – You cannot switch – The machine is not the appliance on switched on at the machine on at the mains mains – Fuse defective or tripped ^ Test the fuse and change if... -
Page 41: Faults With "Err" In The Display, Without The Dishwasher Switching Off Automatically
^ If the fault persists, take a note of the fault code and contact the Miele Service Department. ^ Call the Miele Ser- Err 2, 3, 4, 6, – The dishwasher is not 7, 8, 9, 10 ready for use vice Department. -
Page 42: Faults With "Err" In The Display, And Dishwasher Switches Off Automatically
If the machine completely breaks down and becomes unusable, it will switch off automatically and display a fault code. Display Possible cause Remedy ^ Call the Miele Service Dishwasher switches Mechanical fault itself off and displays Department. fault code Err 1;... -
Page 43: Error Message Indicated By The X Control
The water temperature in the boiler or tank has risen above 95°C Symbol y lights up, and fault code Err 2 or Err 3 shows in the display. Contact the Miele Service Department. Do not switch the dishwasher on. Control X lights up red: The water in the boiler or tank is below the required temperature (when the dishwasher is first switched on). -
Page 44: Fault Indications On Dishwashers With Special Features
Correcting minor faults Fault indications on dishwashers with special features Display Problem Cause/Effect Remedy ^ Replenish the – Cleaning agent or – The dishwasher is not cleaning agent or rinsing agent low ready for use rinsing agent. ^ Replenish the salt –... -
Page 45: Installation
Installation Please refer to the installation Dishwashers fitted with additional diagram supplied with the machine. accessories, such as water Furniture and fittings installed softeners, pressure pumps etc, need near the machine must be of a to be installed with these in mind. commercial standard able to withstand the effects of steam and condensation. -
Page 46: Electrical Connection Uk
MUST BE EARTHED ^ Equipotential bonding should be carried out. ^ The mains connection cable may only be replaced by an original Miele spare part or an apppropriate cable with wire end ferrule. ^ For technical data see data plate or wiring diagram supplied. -
Page 47: Plumbing
6 bar (600 kPa). If the water pressure is not between 0.8 and 6 bar (80 - 600 kPa), please contact the Miele Service Department for advice. ^ The machine is supplied as standard for connection to a hot water supply up to a max. - Page 48 Plumbing Drainage Please refer to the installation diagram supplied with the machine. ^ The dishwasher drainage system is fitted with a non-return valve which prevents dirty water from flowing back into the machine via the drain hose. ^ The dishwasher is supplied with a flexible drain hose, approx.
-
Page 49: Technical Data
Technical data Height with hood open 1.932 mm Height with hood closed 1.469 mm Width: 635 mm Depth: 746 mm Weight (net): approx. 118 kg Operating weight approx. 160 kg Tank volume: 42 l Tank temperature: 65 °C Voltage: see data plate Rated load: see data plate Fuse rating:... -
Page 50: Customer Contact
Customer contact Should you have any difficulties please contact your authorised Service Dealer or the Miele Service Department. – See back cover for contact details. Please quote the model and serial number of your machine. This information can be found on the data plate (see also “Electrical... - Page 52 Alteration rights reserved / 2803 M.-Nr. 05 905 900 / 00 This paper consists of cellulose which has been bleached without the use of chlorine.