Table of Contents
Advertisement
Failed BiT 0 - Panel LEDS
Roomba Symptom: Roomba lights do not turn on.
Connect an *approved* top shell to Roomba and
redo BiT step. If BiT step passes, Roomba is working
and we should now inspect the failed top shell.
Inspect wiring and soldering under the failed top
shell. Are any pcb wires broken or disconnected?
If buttons are not working or intermittent and the
Roomba is a Discovery, SE or Scheduler, open the
user interface panel. Clean the pcb under the snap
dome with alcohol and reapply tape to seal switch
from dirt.
o Inspect the wiring into the user panel and add hot
glue if it is needed for strain relief.
o Ensure BiT passes.
Top Cover/Shell
17
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Roomba Scheduler and is the answer not in the manual?
Questions and answers