Plugging In The Printer - Intermec EasyCoder 3240 Getting Started Manual

EasyCoder 3240 Printer Getting Started Guide

Plugging In the Printer

The back of the 3240 printer contains the AC power cord receptacle, the serial
communications port, the On/Off (|/O) switch, and two banks of DIP
switches.
To plug in the printer
1. Turn the On/Off switch to the off (O) position.
2. Make sure you set the DIP switches to their factory default settings.
3. Plug the AC power cord into the receptacle at the rear of the printer.
4. Plug the other end of the power cord into a grounded wall outlet or surge
5. Turn the On/Off switch to the on (|) position. When you power on the
1-6
Top Bank Set switch 1 on. Set switches 2 through 8 off.
Bottom Bank Set switches 1 through 8 off.
O
AC power cord
receptacle
protector.
printer, the green LED lights, the yellow LED flashes, and the platen roller
advances. The yellow LED then stays on until you load media.
Factory
Default Settings
DIP
ON
switches
Serial
communications
port
On/Off
switch
ON
3240G.003
OFF
OFF