Esc Activation/Malfunction Indicator Light And Esc Off Indicator Light - Jeep Grand Cherokee SRT8 2012 Owner's Manual

WARNING!
If TSC activates while driving, slow the vehicle
down, stop at the nearest safe location, and adjust the
trailer load to eliminate trailer sway.
ESC Activation/Malfunction Indicator Light And
ESC OFF Indicator Light
The "ESC Activation/Malfunction Indicator
Light" in the instrument cluster will come on
when the ignition switch is turned to the ON
position. It should turn off with the engine
running. If the "ESC Activation/Malfunction Indicator
Light" comes on continuously with the engine running, a
malfunction has been detected in the ESC system. If this
light remains on after several ignition cycles, and the
vehicle has been driven several miles (kilometers) at
STARTING AND OPERATING 407
speeds greater than 30 mph (48 km/h), see your autho-
rized dealer as soon as possible to have the problem
diagnosed and corrected.
The "ESC Activation/Malfunction Indicator Light" (lo-
cated in the instrument cluster) starts to flash as soon as
the tires lose traction and the ESC system becomes active.
The "ESC Activation/Malfunction Indicator Light" also
flashes when TCS is active. If the "ESC Activation/
Malfunction Indicator Light" begins to flash during ac-
celeration, ease up on the accelerator and apply as little
throttle as possible. Be sure to adapt your speed and
driving to the prevailing road conditions.
NOTE:
• The "ESC Activation/Malfunction Indicator Light"
and the "ESC OFF Indicator Light" come on momen-
tarily each time the ignition switch is turned ON.
• Each time the ignition is turned ON, the ESC system
will be ON even if it was turned off previously.
5