Allen-Bradley 1609-P3000N User Manual page 11

N
OTE
F
UNCTION
Low Bypass Point
Output Voltage
Output Frequency
Number of
Battery Packs
Connecting the EPO (Emergency Power Off) Option
The output power can be disabled in an emergency by closing a switch connected to the EPO.
Adhere to National and local electrical codes when wiring the EPO.
Rockwell Automation recommends Allen-Bradley Catalog Number 800F Emergency Stop Operator
as the interface to the EPO to connector.
The EPO switch is internally powered by the UPS for use with non-powered switch circuit breakers.
The EPO circuit is considered a Class 2 circuit, (UL, CSA standards) and a SELV circuit (IEC
standard).
Both Class 2 and SELV circuits must be isolated from all primary circuitry. Do not connect any
circuit to the EPO terminal block unless it can be confirmed that the circuit is Class 2 or SELV.
If circuit standard cannot be confirmed, use a contact closure switch.
: S
ETTINGS ARE MADE THROUGH SUPPLIED
N M
OPTIONAL ETWORK
F
ACTORY
D
EFAULT
-30% of output
voltage setting
3 kVA 120 V
models:
120 VAC
208/230 V models:
230 VAC
Automatic
50 ± 3 Hz or
60 ± 3 Hz
1
P
OWER
,
ANAGEMENT CARDS OR
U S
SER ELEC TABLE
C
HOICES
-15%, -20%, -25%, -30%
3 kVA 120 V models:
120 VAC
208/230 V models:
200, 208, 220, 230,
240 VAC
50 ± 3 Hz
50 ± 0.1 Hz
60 ± 3 Hz
60 ± 0.1 Hz
Number of Connected
Internal Battery Packs,
(two modules per pack)
10
C ,
HUTE SOFTWARE
T M .
ERMINAL ODE
D
ESCRIPTION
Minimum voltage that the UPS
will pass to connected
equipment during internal
bypass operation.
Allows the user to select the on
battery output voltage.
Sets the allowable UPS output
frequency. Whenever possible,
the output frequency tracks the
input frequency.
Defines the number of
connected battery packs for
proper run time prediction.