Test / Inspection Menu - MUTOH Rockhopper II series Maintenance Manual

5.4. TEST / INSPECTION MENU

In the Inspection menu, you can perform various inspections on the circuit boards, sensors and fans.
The Inspection menu includes the following diagnosis items.
Initialization item Description
Memory size This menu displays the memory size.
Version Displays the versions of the firmware and mainboard
assembly.
Operation panel Used to check the functions of the operation panel keys,
LCD, and LED.
Sensor This menu displays the sensor status in the operation
panel.
Encoder Displays the detected values from the following encoders.
Fan This menu is used to check if the fan operates normally by
turning ON and OFF the fan.
History Used to check the following records.
Head waveform This menu is used to check the head-driving signal.
Firmware version
Backup parameter version
Setting of dip switches
Revision of mainboard assembly
CR_HP sensor
Cover sensor
Lever sensor
P_EDGE sensor
P_REAR sensor
HD_SLIDE sensor
Thermistor sensor
Ink ID sensor
Ink NOT sensor
Ink END sensor
CR (Carriage)
PF (Media feed)
Maintenance history
Serious error history
* Test *
F1 →
RamCapacity
F3 →
Panel
* Test *
F1 → Encoder
F3 →
Elec.
Rockhopper II series printers – Maintenance Manual
Version
Sensor
(1/2)
Fan
Head Signal
(2/2)
142
Refer to
→ Ram Capacity Menu
→ Version Menu
→ Operation Panel Menu
→ Sensor Menu
→ Encoder Menu
→ Fan Menu
→ History Menu
→ Head Signal Menu
← F2
← F4
← F2
← F4
AP-74065, Rev. 1.2, 27/09/04