Table of Contents
Advertisement
1
Put the vehicle on level ground.
2
The "toe-in" of the front wheels should be 10mm~20mm(0.4in~0.79in). It means the dimension A
should be more 0.4i~0.79 inches than dimension B.
3
Turn the steering wheel to put the steer shaft in the center position, see Pic 7.37.
4
Loose the adjustment nuts on both ends of Front Tie Rods. Turn the 2 tie-rods forwards to
increase A and decrease B, backwards to decrease A and increase B. repeat it until the
dimension A and B meet the requirement described as item a. and then tighten all the v nuts on
the both end of tie-rod.
Fuses and relays
The front fuses and relays box is located to frame under the hood .To check or replace fuses:
1.
Take off the cover of the fuse box. Press the hook down and pull off the cover, see Pic 7.38-Pic
7.39
2.
Check and replace the fuse according the fuses and relays diagram.
The rear fuses and relays box is located to frame behind the passenger seat, see Pic 7.40. Do the
above to check or replace fuses.
51 / 278
Advertisement
Table of Contents
