Brake Pedal - Joyner Renegade R2 Owner's Manual

1 Loosen the flange nut M10x1.25 on the accelerator cable to make the cable can move freely.
2 Loosen the two flange nut M6 and the hex bolts M6x45, M6x60.
3 Adjust the hex bolts to change the dimension L
foot until you feel very comfortable and smoothly.
4 Make sure there is a free travel (L
5 Fasten the nut M6 and M10x1.25.
Before you ride your Renegade first time, it is very necessary to adjust the pedal again to fit you
to avoid tiredness.
The release spring is very important to release the pedal to the rest position when released, so
never remove it off and keep it be its original position which we have done for you.
Check the ripple bush of the cable without break before your Renegade will go into deep water,
or the slurry will comes into the cable. In Winter, once the slurry frozen and the cable will
becomes broken easily.

Brake pedal

The brake pedal is located in the middle of the three control pedals (See Pic 6.11) and controlled by
right foot. Applying pressure to the pedal applies pressure to the brake caliper around the brake disc
at the front and rear wheels and slows or stops the vehicle.
The diagonal brake system on your Renegade provides more safety for you when ride, see parts
manual (Pag 182).
Same to accelerator pedal, it is very necessary to adjust the brake pedal again before your first riding.
Adjust the pedal and keep the distance between the pedal and the bottom board should be
135(5.3in) at least, or else there will be no enough travel for the master cylinder to provide
enough brake force to stop your Renegade.
Adjust the pedal and must fasten the flange nut M6 to make sure the rod cannot come out from
(see Pic 6.12) and press the pedal with you right
2
=10mm/0.4in) about the pedal.
1
32 / 278