Differential-Locker Holder; Accelerator, Brake, Clutch Pedal - Joyner Renegade R2 Owner's Manual

Differential-locker holder

There is differential both the front and the rear differential. When lock them, it can get more power of
your Renegade. SAFETY IS FIRST, before engage the locker, please read the label (label
code:JOYNER-099, see Pic 2.9) which is stuck near by the handle carefully.
There is a big difference about the differential-locker holder between the old and the new dash. The
next Pic 6.10 shows the old locker holder and the Pic 6.11 shows the new one.
Stop your Renegade fully, then operate the handle.
When the handle stop at the upper position, the differential-locker is out off use.
Pull the handle down so that the differential-locker is engaged.
After engaged the locker, check the differential status by moving your vehicle slowly.
Never remove the operation instruction label stunk near by the handle off. If it becomes difficult to
read, a replacement label is available from your local JOYNER dealer.
Read the label carefully and understand the full mean.
The left handle controls the rear differential and the right controls the front.
Never use 4WD with both front differentials locked and rear differential locked at a high speed,
because the work mode of 4WD with both front differentials locked and rear differential locked will
make the steering hard.

Accelerator, Brake, Clutch pedal

Accelerator pedal
Press the accelerator pedal down to increase engine rotate speed and the vehicle riding speed. In the
manufacturer, we have adjusted the accelerator pedal L
and it is very necessary to adjust it again as the follow.
=120mm(4.72in). Maybe it does not fit you
2
31 / 278