Table of Contents
Advertisement
1
Loosen the flange nut M10x1.25 and the thin nut M8 to make the cable and the parking arm can
move freely.
2
Adjust the master rod to make sure the distance between rod holder and the master cylinder
L=18mm (0.71in)-22(0.87in), then fasten the nut.
3
Adjust the round nut M8 and the flange nut M10x1.25 to make sure there is a 10mm (0.4in) free
travel for the parking lever, and fasten the nut.
4
If the cable has broken, please change a new one ASAP.
Differential lock cable adjustment
After a long time used, the throttle cable may be too loose to work well, so adjustment is needed. It is
recommended to adjust the differential lock cable refer to Preventative maintenance and service log.
Loosen the 2 round nut, and then turn the screw sleeve counterclockwise a few round until the
cable get a proper tension.
Operate the handle to check cable and locker can engage well, and then fasten the round nut.
46 / 278
Advertisement
Table of Contents
