Table of Contents
Advertisement
VoiceFinder AP100 VoIP Gateway Installation Guide (Edition 1.0)
2.2. Preparatory Information on Network Access
Conform to the EMI standard and distance limitations in accordance with the EIA
standard during installation.
The following section describes the Ethernet cables and console cables supported by
VoiceFinder AP100 as well as tools required for installation:
2.2.1. Tools for Installation
If you do not place an order on tools required for installation in addition to some cables and devices,
they would not be contained in the product package box. Prepare the following tools and devices for
installation:
Standard screw driver set
Cable for LAN and Console Port
RJ-45 to RJ-45 cable for the LAN port
Cable for Phone Port
RJ-11 to RJ-11 cable for regular phone lines
2.2.2. Ethernet Port
The rear panel of VoiceFinder AP100 is equipped with two RJ45 10/100 Mbps Fast Ethernet ports,
and the front panel is equipped with the LEDs that display LAN, FXS, PSTN port status. Use the
standard cable and connector if you want to access the LAN network by using this port. Refer to the
cable specification of Appendix for information on the pin specification of Ethernet cables.
AddPac Technology Proprietary & Documentation
40 - 22
Advertisement
Table of Contents
