Renault TWINGO Driver's Handbook Manual page 95

cRUISe coNtRol - SPeeD lIMIteR: cruise control function
2 3
4
Putting the function on
standby
The cruise control function is sus-
pended when you press:
– press switch 4 (O);
– the brake pedal;
– depress the clutch pedal or shift into
neutral if the vehicle has a Quickshift
gearbox.
In all three cases, the cruising speed
is stored. The speed appears between
brackets on the display and the box
around the indicator light goes out to
confirm the function is on standby.
Returning to the cruising speed
If a speed is stored, it can be recalled,
once you are sure that the road condi-
tions are suitable (traffic, road surface,
weather conditions, etc.). With a vehicle
speed above 20 mph (30 km/h), press
5
switch 5 (R).
When recalling the stored speed, acti-
vation of the cruise control is confirmed
by the illumination of the strip around
the indicator light.
Note: if the speed previously stored is
much higher than the current speed,
the vehicle will accelerate more rapidly
to reach this threshold.
When the cruise control is sus-
pended, pressing switch 2 (+) or 3
(-) reactivates the cruise control
function without taking into account
the stored speed: it is the speed at
which the vehicle is moving that is
taken into account.
(continued)
1
Switching off the function
The cruise control function is deacti-
vated if you press switch 1: in this case
a speed is no longer stored. The instru-
ment panel indicator light goes out, con-
firming that the function is stopped.
Putting the cruise control
on standby or switching it
off does not cause a rapid
reduction in speed: you
must brake by depressing the brake
pedal.
2.21