Renault TWINGO Driver's Handbook Manual page 43

ChILD sAFETY: Fitting a child seat
X = Seat not suitable for fitting child seats.
U = Seat allowing a child seat with "Universal" approval to be attached by seat belt; check that it can be fitted correctly.
IUF/IL = On equipped vehicles, seat which allows a child seat with "universal/semi-universal or vehicle specific" approval to be at-
tached using the ISOFIX device; check that it can be fitted correctly.
(2) Before fitting a rear-facing child/baby seat: raise the seat to the maximum and position it as far back as possible, tilting the
seatback slightly (approximately 25°).
(3) It is recommended to position the rear seat as far back as possible ensuring, if required, that the floor support of the child/baby
seat is resting on the floor in accordance with the child/baby seat instructions.
(4) A carrycot can be installed across the vehicle and will take up two seats. Position the child with his or her feet nearest the
door.
(5) Move the front seat as far forward as possible to install a rear-facing child seat, then move back the seat or seats in front in
accordance with the child seat instructions.
(6) Forward-facing child seat; position the seatback of the child seat in contact with the seatback of the vehicle seat. Adjust the
height of the headrest or remove it if necessary; do not push the seat in front of the child more than halfway back on its runners
and do not recline the seatback more than 25°.
(continued)
1.37