Inspection And Maintenance; Inspection; Checking The Flue Pipes And Air Supply Pipes For Leaks - REMEHA Avanta 12v Installation & Service Manual

3

INSPECTION AND MAINTENANCE

fig. 48 Annual inspection
fig. 49 Checking flue pipes
The Remeha Avanta is practically maintenance free but should
be inspected annually.

If during the annual inspection the flue gas analysis indicates
that the values are outside the figures given in table 09, main-
tenance work should be carried out as described in par.3.2.
Also carry out maintenance if the ionisation read-out value is
lower than 3 or higher than 9μA, or when the flame core is not
correct.
Only Remeha spare parts/materials should be used.
All service and maintenance must be carried out by a qualified
Engineer with the relevant training and certification (i.e. ACS
- IEE registrations etc).
3.1

Inspection

The annual inspection of the Remeha Avanta can be limited to
the following checks:
- check the flue pipes and air supply pipes for leaks, see par.
3.1.1.;
- check and clean (if necessary) the condensate siphon, see
par.3.1.2.;
- check the ignition electrode and ionisation, see par. 3.1.3;
- check the combustion and flame pattern, see par. 3.1.4;
- Fill in the Benchmark Service Record on the inside back
pages of this document.
59970LTGBW7H022
3.1.1 Checking the flue pipes and air supply pipes for
leaks
• Check that the flue and air-supply connections and pipes
are sealed and the terminal exit is clear.
59970LTGBW7H023
39