Forward/Backward Feed - Brother XR9000 Service Manual

Adjustment
1. Attach the front cover assy..
2. Start the test mode.
3. Select the pattern number "05" (Forward and reverse feed mode).
4. Insert a paper between folded broadcloth, and press the
and reverse feed mode", checking the forward and backward feed length.
5. Remove the base cover A.
6. Loosen the socket screw (M3 x 8) of the FPM holder assy..
7. Adjust the forward and backward feed length turning the socket screw (M4 x 25) of the FPM holder assy..
*Key point
The forward feed should be 0 to 10 mm longer then the backward feed.
• Tightening the socket screw (M4 x 25) the backward feed shorter.
• Loosening the socket screw (M4 x 25) the backward feed longer.
8. Apply a small amount thread locker to the socket screw (M4 x 25).
9. Tighten the socket screw (M3 x 8) of the FPM holer assy..
10. Attach the base cover A.
Socket
screw (M3 x 8)
4 - 14

Forward/backward feed

Socket
screw (M4 x 25)
Forward feed
(Start/Stop button) to run the machine in "Forward
0 - 10mm
Backward feed