Presser Bar Attachment - Brother XR9000 Service Manual

Main unit
9

Presser bar attachment

1. Attach the presser feed holder assy. 2 to the presser bar 1 with the screw
1.
2. Attach the J foot 3.
3. Apply a light covering of OILER to the circumference of the presser bar 1
(upper 20 mm).
4. Insert the lower end of the presser bar 1 into the base holder 4, and then
attach the presser bar 1, presser bar clamp 5, and spring 6 in this order
to the base holder 4.
5. Temporarily tighten the screw 2 to the presser bar clamp 5.
*Key point
• Tighten after performing "4 - 13 Presser bar height and
parallelism".
• Adjust the distance from the base holder bottom face to the tip
of the presser bar 1 to approximately 50 mm.
Apply OILER to the circumference of the presser bar
(upper 20 mm).
1
2
Needle-presser unit
Light covering
Screw
3.57
1.18 — 1.57 N
Screw stud
M5
Hand tighten
XZ0206***
1
Torque
·
m
Torque
1
2 1 3
6 5
4
2
3 - 43