Adjustment
1. Attach the front cover temporarily.
2. Start the test mode.
3. Select the pattern number "02" (3-point needle drop mode).
4. Move the needle to the left with the
5. Turn the pulley by hand, until the needle top comes to the needle plate surface.
6. Loosen the 2 screws (giza tite 5 x 16).
7. Move the rotary hook unit right and left, and adjust the needle top drops in the right side of "V" groove on the
needle plate A.
8. Tighten the 2 screws (giza tite 5 x 16).
Screw (giza tite 5 x 16)
Rotary hook unit position
(Reverse stitch button), and then turn the power off.
"V" groove
Screw (giza tite 5 x 16)
Needle top
drops in
shadow area.
4 - 7