Lamp Adjustment; Inserting/Exchanging Colours - Robe 250 AT User Manual

4.2 Lamp adjustment

3 adjustment screws "A,B,C"
The ColorWash 250 AT lamp holder is aligned at the factory. Due to differences between lamps, fine adjust-
ment may improve light performance.
Strike the lamp,open the shutter and set the dimmer intensity onto 100% and aim the light on a flat surface
(wall).Center a hot-spot(the brightest part of the image) by using the 3 adjustment screws "A,B,C".Turn one
screw after another a quarter-turn clokwise(counter-clokwise) to set the hot-spot in the center of the image.If
you cannot detect the hot-spot,adjust the lamp until the light is evenly distributed.

4.3 Inserting/Exchanging colours

DANGER!
Install the colours with the device switched off only.
Unplug from mains before!
If you wish to change colours ,open the top cover of the head by loosening the 4 quarter-turn fasteners on the
top cover.
Gently bend out the colour module to release it from the 3 distance slots and eject it from the pressing snap.
Put the new colour module back under the pressing snap and push it to the distance slots.
colour-module
pressing snap
7