Installing The Lamp; Lamp Adjustment - Robe Robin MMX Blade User Manual

Hide thumbs Also See for Robin MMX Blade:
Table of Contents

Advertisement

4.2 Installing the lamp

DANGER ! Install the lamp with the device switched off only.
To insert the new lamp.
1. Disconnect the fixture from power and allow it to cool
at least 5 minutes.
2. Make sure that the fixture´s head is in the position as
shown on the picture (notices on the lamp cover are in
readable position) .Loosen the two quarter-turn
fasteners () marked "X,Y" on the lamp cover to
open this cover.
3. Holding the lamp by its ceramic base, carefully
turn the lamp to the left to loosen the lamp from
the lamp holder.
Gently pull the lamp out of the lamp holder
4. Holding the new lamp by its ceramics base, gently
insert the lamp to the lamp socket and turn the base
to the right. Make sure that the lamp is installed tightly
into the lamp socket.
Do not install a lamp with a higher wattage! A lamp like
this generates temperatures the device is not designed
for. Damages caused by non-observance are not subject to warranty.
Please follow the lamp manufacturer's notes! Do not touch the glass bulb bare hand during the
installation!
5. Re-insert the lamp cover and tighten the two quarter-turn
fasteners ().
6. Switch on the fixture.
7. Align the lamp (see instructions below)
8. Reset the "Lamp On Time" and "Lamp Strikes" counters
in the menu "Information".

4.3 Lamp adjustment

The lamp holder is aligned at the factory. Due to differences between lamps,the fine adjustment may improve
light performance:
To adjust the lamp in the fixture.
1. Switch on the fixture and after its reset turn on the
lamp.
. Go to the "Service" menu and select the item "Adjust
Lamp" to project the light beam on the wall.
3. Use items in this menu to focus the light beam and set
the item HotSpot at 0 DMX .
4. Turn adjustment screws marked "A, B, C" () one after
another until you reach a max. light intensity (.
5. Center the hot-spot (the brightest part of the beam)
using these 3 adjustment screws ().
Unplug from mains before !
Do not operate this fixture with open lamp cover!
7

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Robin mmx blade wireless dmx crmx

Table of Contents