Installation; Fitting/Exchanging The Lamp; Lamp Adjustment - Robe Color mix 575 AT User Manual

4.Installation

4.1Fitting/Exchanging the lamp

DANGER !
Install the lamp with the device switched off only.
Unplug from mains before !
Lamp cover:
3 fastening screws
To insert the lamp MSR 575W/2 open the small cover at the rear of the projector by loosening the 3 screws „X, Y, Z" on the lamp
cover.
Gently pull out the lamp socket assembly.
If changing the lamp, remove the old lamp from the socket. Insert the lamp to the socket.
Do not install a lamp with a higher wattage! A lamp like this generates temperatures the device is not designed for.
Damages caused by non-observance are not subject to warranty. Please follow the lamp manufacturer's notes!
Do not touch the glass-bulb bare hand during the installation! Make sure that the lamp is installed tightly into the lamp holder system.
Reinsert the lamp assembly and tighten the 3 screws again.
Before striking the lamp, reset the "LAti/rSEt" and "LASt/rSEt"counters in the "InFO" menu on the control panel, by pressing
the [ Up ] and [ Down ] buttons in one time and then confirming with the [ Enter ] button.
Do not operate this fixture with opened housing-cover!

4.2Lamp adjustment

The lamp holder is aligned at the factory. Due to differences between the lamps, fine
adjustment may improve light performance.
Strike the lamp, cancel all effects, open the shutter and set the dimmer intensity to
maximum and focus the light on a flat surface (wall) or use function "LAAd" in the
Special functions of the control board .
Center the hot-spot (the brightest part of the beam) using the 3 adjustment screws „A, B,
C". Turn one screw at a time to drag the hot-spot, diagonally across the projected image. If
you cannot detect a hot- spot, adjust the lamp until the light even.To reduce a hot-spot, pull
the lamp in by turning all three screws „A, B, C" clockwise 1/4-turn at a time until the light is
evenly distributed.If the light is brighter around the edge than it is in the center, or if light output
is low, the lamp is too far back in the reflector. „Push" the lamp out by turning the screws „A,
B, C" counterclockwise 1/4-turn at a time the light is bright and evenly distributed.
adjusting screws „A, B, C"