Installation; Fitting/Exchanging The Lamp; Lamp Adjustment - Robe CLUBSPOT 160 CT User Manual

4.Installation

4.1Fitting/Exchanging the lamp

To insert the lamp CDM-SA/T 150/942 open the small lamp cover at the rear of the head (see the drawing) by
loosening the 4 screws „W, X,Y, Z," on the lamp cover.
Gently pull out the lamp assembly.
If changing the lamp, remove the old lamp from the socket. Insert the lamp to the socket.
Do not install a lamp with a higher wattage! A lamp like this generates temperatures the device is not designed
for.
Damages caused by non-observance are not subject to warranty. Please follow the lamp manufacturer's notes!
Do not touch the glass-bulb bare hand during the installation! Make sure that the lamp is installed tightly into the
lamp holder system.
Reinsert the lamp assembly and tighten 4 screws again.
Before striking the lamp, reset the "LAti/rSEt" and "LASt/rSEt"counters in the "InFO" menu on the control
panel, by pressing the [
Do not operate this fixture with opened housing-cover!

4.2Lamp adjustment

The CLUBSPOT 160 CT lampholder is aligned at the factory.
Due to differences between lamps, fine adjustment may improve
light performance.
Strike the lamp, cancel all effects, open the shutter and set
the dimmer intensity onto 100 % and focus the light on a flat
surface (wall) or use function "LAAd" in the Special
functions .
Center the hot-spot (the brightest part of the beam) using the 3
adjustment screws „A, B, C". Turn one screw at a time to drag
the hot-spot, diagonally across the projected image. If you cannot
detect a hot -spot, adjust the lamp until the light is even.
Install the lamp with the device switched off only.
Unplug from mains before !
] and [ ] buttons in one time and then confirming with the [
DANGER !
Lamp cover:
6
screws "X,Y,Z W"
] button.
screws "A, B, C"