Korenix JetNet 5228G Series User Manual page 210

3
Configuring the Switch
CLI – This example sets the priority for MSTI 1, and adds VLAN 1 to this MSTI. It
then displays the STA settings for instance 1, followed by settings for each port.
Console(config)#spanning-tree mst configuration
Console(config-mst)#mst 1 priority 4096
Console(config-mstp)#mst 1 vlan 1
Console(config-mst)#end
Console#show spanning-tree mst 1
Spanning-tree information
---------------------------------------------------------------
Spanning Tree Mode:
Spanning Tree Enabled/Disabled:
Instance:
VLANs Configuration:
Priority:
Bridge Hello Time (sec.):
Bridge Max Age (sec.):
Bridge Forward Delay (sec.):
Root Hello Time (sec.):
Root Max Age (sec.):
Root Forward Delay (sec.):
Max Hops:
Remaining Hops:
Designated Root:
Current Root Port:
Current Root Cost:
Number of Topology Changes:
Last Topology Change Time (sec.): 452
Transmission Limit:
Path Cost Method:
---------------------------------------------------------------
Eth 1/ 7 information
---------------------------------------------------------------
Admin Status:
Role:
State:
External Admin Path Cost: 100000
Internal Admin Path Cost: 100000
External Oper Path Cost:
Internal Oper Path Cost:
Priority:
Designated Cost:
Designated Port:
Designated Root:
Designated Bridge:
Fast Forwarding:
Forward Transitions:
Admin Edge Port:
Oper Edge Port:
Admin Link Type:
Oper Link Type:
Spanning Tree Status:
. .
.
3-164
MSTP
Enabled
1
1
4096
2
20
15
2
20
15
20
20
4096.1.0012CF7D25BC
0
0
0
3
Long
Enabled
Designate
Forwarding
100000
100000
128
0
128.1
4096.1.0012CF7D25BC
4096.1.0012CF7D25BC
Enabled
2
Enabled
Enabled
Auto
Point-to-point
Enabled
4-207
4-208
4-208
4-218