4.6 Top cover assembly
4.6
Top cover assembly
Removing the Top cover assembly
To remove the top cover assembly, follow the steps below and refer to Figure 4-7 to 4-9.
1. Peel off the glass tape and disconnect the speaker cable from the connector CN6350
on the SD board.
2. Disconnect the Bluetooth antenna cable from the Bluetooth module.
3. Disconnect the LCD cable, FL cable, FP cable and Accupoint cable from the
connectors CN5600, CN9650, CN9700 and CN3240 on the system board.
LCD cable
FP cable
Accupoint cable
libretto U100 Maintenance Manual (960-520)
FL cable
Figure 4-7 Removing the top cover assembly (1)
4 Replacement Procedures
Glass tape
Bluetooth antenna cable
Speaker cable
[CONFIDENTIAL]
4-17