Toshiba libretto U100 Maintenance Manual page 242

4 Replacement Procedures
6. Disconnect the keyboard flexible cable from the connector CN3230 on the system
board and remove the keyboard.
Keyboard flexible cable
Installing the Keyboard
To install the keyboard, follow the steps below and refer to Figure 4-5 and 4-6.
1. Place the keyboard face down on the palm rest and connect the keyboard flexible
cable to the connector CN3230 on the system board.
2. Turn the keyboard face up and put it on the computer. Make sure that there is no gap
between the keyboard and the computer.
3. Secure the keyboard with the following screws.
• M2×3S
4. Install the keyboard hold plate and secure it with the following screw.
• M2×4B
5. Install the keyboard holder while inserting it to the slot on both sides.
6. Turn the computer upside down and secure the keyboard with the following screw.
• M2×14B BIND screw
4-16 [CONFIDENTIAL]
CN3230
Figure 4-6 Removing the keyboard
S-FLAT HEAD screw
BIND screw
×2
×1
×1
libretto U100 Maintenance Manual (960-520)
4.5 Keyboard
Keyboard