Toshiba libretto U100 Maintenance Manual page 217

3.29 SETUP
For the Alarm Time, set the time to turn on the power automatically. The
"second" cannot be set. When it is set to "Disabled", the time to turn on
automatically is not set.
For the Alarm Date Option, set the date to turn on the power automatically.
When it is set to "Disabled", the time to turn on automatically is not set.
The Wake-up on LAN is a function to turn on the power automatically by the
call from the administrator. It can be set to "Enabled" only when "Built-in
LAN" is set to "Enabled". To activate this function, use the AC adapter.
NOTE: 1. Do not remove the AC adaptor and battery pack at the same time when you
use this feature. If you do so, data saved by the resume function will be lost.
You must also reset this option.
2. If you have set a password and the computer boots by the Auto Power On
function and Resume is on, the computer will start with the instant security
function enabled. The password = message is not displayed; however, you
must enter the password to use the computer.
3. This option is enabled only once, the setting is reset, after booting up.
(d) Panel Power On/Off
This option is displayed only in the resume mode.
Enabled
Disabled
(e) Performance/Battery Life Setting
Use this option to choose a setting of Memory Bus Clock and Graphics Core
Clock/Voltage from the followings.
Performance
Battery Life
Memory Bus Clock and Graphics Core Clock are set as shown below.
Memory Bus clock (MHz)
Graphics Core clock (MHz)
libretto U100 Maintenance Manual (960-520)
Enables the Panel Power On/Off.
Disables the Panel Power On/Off. (Default)
Performance has priority.
saving power by setting in lower clock and voltage.
(Default)
Battery Life
3 Tests and Diagnostics
Performance
266
200
[CONFIDENTIAL]
333
250
3-99