Toshiba libretto U100 Maintenance Manual page 215

3.29 SETUP
(b) HDD Priority
Set the priority of the HDD as a startup device.
Built-in HDD→USB The priority is set as built-in HDD→USB (Default)
USB→Built-in HDD
NOTE: When a boot command is not found in the designated HDD, other device, not the
other HDD, boots the computer up.
(c) Network Boot Protocol
Use this option to set the starting method via a network.
PXE Sets to PXE protocol. (Default)
RPL Sets to RPL protocol.
6. Display
This group of options configures the computer's display.
(a) Power On Display
This option is used to select the display when booting up.
Auto-Selected
LCD+AnalogRGB
NOTE: When starting the computer in Resume mode, the last configuration is enabled.
When data does not appear on the display after starting in Resume mode,
pressing Fn+F5. Pressing Fn+F5 changes the display setting as follows in
order: the internal LCD, the external display, both the internal LCD and the
external display.
When an external display, which does not support SVGA mode is connected and
"LCD+AnalogRGB" is selected, the external display is not displayed.
(b) LCD Display Stretch
LCD Display Stretch enables or disables a larger display area of the screen.
Enabled
Disabled
libretto U100 Maintenance Manual (960-520)
The priority is set as USB memory→built-in HDD.
Selects an external monitor if one is connected.
Otherwise it selects the internal LCD. (Default)
Selects both the internal LCD and the external monitor
for simultaneous display.
Enables the LCD display stretch feature. (Default)
Disables the LCD display stretch feature.
3 Tests and Diagnostics
[CONFIDENTIAL] 3-97