Sanyo PLV-WF10 Service Manual page 8

Lamp counter reset
Be sure to reset Lamp Counter when Lamp Assembly is replaced. When Lamp Replace Counter is reset, LAMP
REPLACE indicator stops lighting.
1 Turn projector on, press MENU button and ON-SCREEN
MENU will appear. Press POINT LEFT/RIGHT button(s) to
move a red frame pointer to SETTING Menu icon.
Press POINT DOWN button to move a red frame pointer to
2
"Lamp counter reset" and then press SELECT button.
3 Move arrow to replaced lamp number (Lamp 1 or Lamp 2) and
then press SELECT button. Message "Lamp replace counter
Reset?" is displayed. Move pointer to [Yes] and then press
SELECT button.
NOTE: Be sure to reset correct lamp number otherwise LAMP
REPLACE indicator continues lighting.
4 Another confirmation dialog box appears and select [Yes] to
reset Lamp Replace Counter.
Caution : Burst
Do not reset
after projection lamp is replaced. Failure to observe
this caution, when the useful life of the lamp passes, the
LAMP REPLACE
been using the lamp over which the useful life passed.
It may cause the burst of the lamp.
LAMP REPLACEMENT COUNTER
indicator do not light. It will have
Move pointer to Lamp counter reset and then
1 2
press SELECT button.
replaced lamp number (Lamp 1 or Lamp
2) and then press SELECT button.
except
Message "Lamp replace counter Reset?" is
displayed. Move pointer to [Yes] and then
press SELECT button.
-8-
Move arrow to
MY6A